BALL, Speedometer Drive Gear, repro, includes 7064 snap ring, Used to retain the speedo drive gear to the output shaft, Correct for use through mid-1970, Mid-70 and on a bi-metal clip was used to retain the gear in the square channel of the 4A style gear, This clip often broke or fell out leaving the gear to spin and cause the speedo to read incorrectly, Using this ball and snap ring on later trans will alleviate this issue with a more secure fit to the shaft, This kit is mandatory when using the current 17285-1 repro gear which is of the type 4 style without the channel for the bi-metal clip
NPD Part Number : 353351-S Manufacturer Reference #'s: DK296-35B, 353351-S, 8A-7064
1965-1973 MUSTANG FORD TOPLOADER 4SM/T, 3.03 3SM/T
1967-1973 COUGAR FORD TOPLOADER 4SM/T, 3.03 3SM/T
1964-1968 FALCON FORD TOPLOADER 4SM/T, 3.03 3SM/T
1964-1971 FAIRLANE FAIRLANE, TORINO, 70 1/2 FALCON, FORD TOPLOADER 4SM/T, 3.03 3SM/T
1955-1957 TBIRD F/M OUTPUT SHAFT, USE BALL ONLY
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Fits very good. Just make sure you have the right Style a ring pliers to open up enough to get it over the edge
Submitted on February 23, 2022 by Robert E.
YES I would recommend this product.
Quality
Value
Submitted on November 30, 2022 by Justin K.
YES I would recommend this product.
Quality
Value
Haven’t installed yet
Submitted on February 21, 2023 by Ronnie S.
YES I would recommend this product.
Quality
Value
looks good quality but was unable to use. I purchased as possible modification to speedometer drive gear but project fizzled. Based on appearances I would say quality is very good, Il give it a 5...
Submitted on September 08, 2023 by Philip K.
YES I would recommend this product.
Quality
Value
In Stock!
