Black billet aluminum. Custom look. Pin location on the 60-64 1/2s is 90 off the 65-66 location. You will have to re-drill for early handles.
See also 2760-5A for RH drive conversion model!
Ford Mustang Years:
1965 (65), 1966 (66), 1967 (67), 1968 (68)
Above years shown are used for searches and are not application listings.
Mercury Cougar Years:
1967 (67), 1968 (68)
Above years shown are used for searches and are not application listings.
Ford Falcon and Ranchero Years:
1960 (60), 1961 (61), 1962 (62), 1963 (63), 1964 (64), 1965 (65)
Above years shown are used for searches and are not application listings.
Ford Fairlane and Ranchero Years:
1964 (64), 1965 (65)
Above years shown are used for searches and are not application listings.
NPD Part Number : 2760-1E Manufacturer Reference #'s: C5ZZ-2760-BLTBK,
1965-1968 MUSTANG
1967-1968 COUGAR
1960-1965 FALCON
1964-1965 FAIRLANE
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
product looks good, uses a set screw to attach to shaft. Time will tell if it will say secured. But it looks a feel good.
Submitted on November 20, 2019 by Leonard C.
YES I would recommend this product.
Quality
Value
I have been annoyed by broken Mustang parking brake handles since the 90's. This seems like such an obvious fix for that dumb old OEM design. It's a beautiful part and from 18" away you'd never guess it wasn't original. It does use a setscrew instead of the factory pin for mounting. I opted to match-locate and drill a dimple on the parking brake shaft to make sure the setscrew gets a good bite. This procedure might be difficult if you don't remove the shaft assembly from the car.
Submitted on December 04, 2020 by Brian P.
YES I would recommend this product.
Quality
Value
it looks like a quality product, unfortunately it didn't fit correctly. the attachment pin is on the wrong side
Submitted on February 19, 2021 by Jeffrey L.
Quality
Value
This handle fit on my 1965 Ford F100 2WD parking brake lever. Note that this handle matches the style of the original handle, but the design is a little bit different. The original was plastic while this is metal. The original handle was also centered on the parking brake lever shaft while this is off-centered to the right. The off-centered design allows a much better grip than the stock handle. The metal construction gives me confidence it will not break like the original did. It does not feel cheap. I do think the price ($48.51 at the time of this writing) is a little steep for the handle, given I have purchased much larger or more complicated parts for cheaper (e.g. a replacement windshield wiper fluid pump for my truck was slightly cheaper) but it is solidly built at least and there are few good replacements available.
Submitted on May 09, 2022 by Zachary S.
YES I would recommend this product.
Quality
Value
Strong, good looking piece.
Submitted on December 29, 2022 by Dennis H.
YES I would recommend this product.
Quality
Value
In Stock!
