HOSE CLAMP KIT, Band Style, date coded 1/66, concours correct, (10), 4 radiator & 6 heater and bypass hose clamps, Date codes are by quarter and not by month 1/66 is 1st quarter 1966, Kits include 4 clamps for radiator, 4 for heater and 2 for by pass hose, Produced using the original Wittek tooling and Wittek trademark, No other reproduction clamp can come this close to the original, Using the original blueprints these clamps are hardened to the proper spec, Correct hot dip galvanized finish for a correct appearance, Unique bridge for each clamp size for a proper seal, These are the best available because they are basically the original clamp!
NPD Part Number : 8287-2CK Manufacturer Reference #'s: HK-9 D661Q,
1966-1966 MUSTANG 289
1966-1966 FALCON 289
1966-1966 FAIRLANE 289
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Great Product. It would be nice if they were labeled. Difficult to differentiate the large and medium while you are under the car.
Submitted on September 26, 2018 by Christopher H.
YES I would recommend this product.
Quality
Value
Submitted on March 29, 2020 by Michael S.
YES I would recommend this product.
Quality
Value
Trying to tighten these clamps while on the hose and keep the bolt perpendicular and centered in the alignment cup is almost impossible. My advice is to put it in a vise first so it won't move and slowly tighten while watching that the bolt doesn't slip out of the alignment cup. Screw it down until you see both sides of the band moving equally then release it. With a head start, the clamp will install on the hose correctly.
Submitted on August 13, 2020 by Jay M.
YES I would recommend this product.
Quality
Value
Very happy. They appear to be duplicates of the original.
Submitted on January 31, 2022 by James W.
YES I would recommend this product.
Quality
Value
The clamps look like they are very high quality but installation is a nightmare. It took me probably a half hour if not longer to tighten them properly. The screw kept working it way out of the cup and it was tightening unevenly. I had to pre-tighten them while constantly working to make sure they were tightening evenly.
Submitted on May 13, 2022 by Dennis Z.
Quality
Value
They fit and do the job while keeping to old look
Submitted on March 07, 2023 by Mark M.
YES I would recommend this product.
Quality
Value