PLATE, Rear Booster Diaphragm, Midland Ross, Needed to complete a rebuild along with the 2309-3A kit, ** Installation warning --The seal on this part is thicker than original to help seal cases that may be warped or distorted, Heavier than normal pressure may be required to compress the case halves to install the band clamp, A press may be required **
Manufacturer Reference #'s: 62-575 (100 min) see Scott 1st,
The part gives the appearance of being excellent quality; however the part that needs to be squeezed to assemble the two halves is too thick. The stock part is 4mm in thickness, this part is 7mm thick. Good luck trying to squeeze the halves together and getting the clamping ring to hold them. I finally refurbished my old one and did not use this.
Submited on October 02, 2018 by Heinz R.
YES I would recommend this product.