PRESSURE HOSE, Power Steering, replacement, lower, junction block to control valve, 5/16 inch pressure port at control valve and includes a brass adapter to fit 1/4 inch pressure port fitting, zinc fittings and line with corrugated black plastic hose armor, ** on 70 models this hose may be very close to the pitman arm at lock **Notes: 1)Replacement hoses are generic fit hoses designed to fit several applications. What you usually see are hoses that may be longer than the original. After installation check for any possible interference and retain as required.2)You must flush the PS system anytime components are replaced to eliminate any contamination and to validate manufacturers warranties.3)We highly recommend to use of Ford type F transmission fluid in the P/S system for proper operation and longer life of the components.
Manufacturer Reference #'s: Sunsong 3401596,
The length of the steel line that mounts into the bracket isolator is too short. I decided to use that one I already had from another vendor since it was the same and fill in the gap between the steel line and isolator with rubber. It should’ve been made to the right length.
Submited on April 26, 2020 by david n.
I did not use
Submited on June 04, 2020 by Vernon R.
I could not use this hose. The fitting for the power head was wrong size. Not sure if the steering in this car is original either. So not the fault of NPD.
Submited on June 05, 2020 by Vernon R.
YES I would recommend this product.