OIL SEAL, Rear Wheel Bearing, 1 3/8 inch I.D. x 2 17/64 inch O.D. x 7/16 inch TK, Seals 1 3/8 inch shaft, used with carrier plate flange on inside of axle housing tube,
NPD Part Number : 1177-5 Manufacturer Reference #'s: National Seal RNT 9569S, C4OZ-1177-A, C7OZ-1177-B, E0DZ-1177-B
1967-1973 MUSTANG FORD 8 INCH AND 9 INCH REAR AXLE, W/ 28 SPLINE AXLE SHAFTS
1967-1973 COUGAR FORD 8 INCH AND 9 INCH REAR AXLE, W/ 28 SPLINE AXLE SHAFTS
1983-1984 RANGER FORD 6.75 INCH REAR AXLE, REAR WHEEL
1970-1970 FALCON (FROM 1/1/70), 28 SPLINE AXLE
1969-1971 TORINO 28 SPLINE AXLE
1968-1968 TORINO USE WITH CARRIER PLATE FLANGE ON INSIDE OF AXLE HOUSING TUBE, EXCL WEZ AXLE OR 427
1968-1968 TORINO WEZ AXLE CODE
1969-1970 FAIRLANE 28 SPLINE AXLE
1964-1968 FAIRLANE USE WITH CARRIER PLATE FLANGE ON INSIDE OF AXLE HOUSING TUBE, EXCL WEZ AXLE OR 427
1967-1968 FAIRLANE WEZ AXLE CODE
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
correct fit for a 1967 Ford 8" axle housing
Submitted on October 02, 2018 by Robert K.
YES I would recommend this product.
Quality
Value
Excellent service, communication and quality.
Submitted on April 25, 2019 by Jason H.
YES I would recommend this product.
Quality
Value
Works perfectly
Submitted on February 26, 2020 by Brian T.
YES I would recommend this product.
Quality
Value
looks and feels just like original parts. I purchased seals from NAPA and they are very cheaply made, smaller and thinner material. NAPA use to be my first choice, not any more, now it's NPD.
Submitted on April 20, 2021 by brian H.
YES I would recommend this product.
Quality
Value
Bought these extra, they fit nicely 28 splines while the other i thought were the right ones were too big (31 splines)
Submitted on June 05, 2021 by Fabrice C.
YES I would recommend this product.
Quality
Value
Delivered as promised. Good part, but the application for my street rod was difficult. I used measurement to closest OD but this seal was probably .020 too large. Cant find an NPD seal listing by size, only application. The tear is a Ford 8” with shortened axle tubes. Flanges measure as “small bearing” Ford, but the seal bore doesnt match. Could use NPD to help me find a solution……
Submitted on February 23, 2022 by Anthony B.
YES I would recommend this product.
Quality
Value
In Stock!
