REAR END LOWERING KIT, 1 inch, Kit includes solid aluminum lowering blocks with chamfered guide holes and press fit steel locating pins, 4 lengthened OE spec U-bolts and nuts
NPD Part Number : 5500-2A Manufacturer Reference #'s: National Parts Depot 5500-2A (K),
1967-1973 MUSTANG
1967-1973 COUGAR ** WILL NOT FIT WITHOUT MODIFICATIONS **
WARNING: This product can expose you to chemicals including lead and DEHP, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Advertised to work for Cougars, but will not work due to different mounting blocks on Cougars than Mustangs. Cougars have an angle wedge plate on top of a leaf mount that kind of captures the leaf pack. You have to modify the aluminum blocks be either drilling out where the locator tab on the angle wedge, or figure out how to drill a 1.25" hole into the center of the aluminum block to mount between the angle wedge and factory leaf mount. Mustangs had different leaf mounts than the Cougars apparently. It can be fitted, just will take some engineering.
Submited on April 06, 2016 by Tim M.
These bolts are too small for my application, I need 1/2 in. diameter bolts.
Submited on August 07, 2018 by Dale M.
Quality
Value
Product fit like a glove and did the trick. Made the stance perfect.
Submited on May 25, 2020 by Hardy B.
YES I would recommend this product.
Quality
Value
The blocks themselves are very well made and fit perfect. The bolts are about 3/4” too long giving a very unprofessional look unless trimmed. Would give five stars if it were not for the ubolts being too long.
Submited on October 21, 2021 by Steve W.
YES I would recommend this product.
Quality
Value
In Stock!
